Water Heaters

How to Flush Out Your Water Heater

  1. Locate and shut off the power source (circuit breaker or fuses) for electric water heaters only; but leave the water supply on. Gas and LP supply valves for non-electric heaters can be left on.
  2. For natural gas and propane (LP) water heaters, make a note of what the temperature setting is and then turn the thermostat (large red dial on the front of the control) to the lowest setting (pilot). If you plan to use the water for other purposes, turn the heat off ahead of time and allow the water to cool (overnight) before draining. Open a faucet closest to the water heater, like the bathroom.
  3. Attach a garden hose to the drain cock located at the bottom of the heater. The drain cock usually looks like a regular hose bib (garden faucet) or a round dial with a threaded hole in the middle. (The drain cock may be hidden under a removable cover.)
  4. Extend the garden hose to a place where the water can safely exit the heater (e.g. a drain, a driveway, etc.). This water is perfect for watering the yard with, once cooled. If you plan ahead, the water can be cool and usable.
  5. Open the drain cock to allow the water to exit the heater. Caution: the water leaving the heater will be hot and under normal household water pressure. Also note that if the drain cock is made of plastic and the heater is several years old, it may be difficult to open and may break easily if forced.
  6. After five minutes of flushing, fill a bucket with the still flushing water.
  7. Allow the water in the bucket to stand undisturbed for a minute and see if the water is clear or if any sand-like material settles to the bottom. If the water is clear and no sand-like material is observed, go on to step 8. If the water is discolored and/or sand-like material is observed at the bottom of the bucket, repeat steps 5 and 6 until the flush water is completely clear and free of sediment.
  8. Close the drain cock and remove the garden hose.
  9. Turn on the electrical circuit breaker or return the gas control to the setting it was previously at and allow ample time for the water to heat back up.

Enjoy the clean water and the longer-lasting, more efficient water heater!

Leave a Reply

Your email address will not be published. Required fields are marked *

error

Enjoy this website? Please spread the word :)

Instagram
Follow by Email
RSS